Save your calibration factor because you’ll need it later. The known weight is 107g, so our calibration factor will be: -49171/107 = -459.542. Then, place an object with a known weight on the scale and wait until you get a value.ĥ) Calculate your calibration factor using the formula: calibration factor = (reading)/(known weight) calibration factor will be the (reading)/(known weight)ģ) After uploading, open the Serial Monitor at a baud rate of 57600 and then press the Arduino on-board RESET button.Ĥ) Follow the instructions on the Serial Monitor: remove any weights from the scale (it will tare automatically). Serial.print("Place a known weight on the scale.") Scale.begin(LOADCELL_DOUT_PIN, LOADCELL_SCK_PIN) The above copyright notice and this permission notice shall be included in allĬopies or substantial portions of the Software. Of this software and associated documentation files. Permission is hereby granted, free of charge, to any person obtaining a copy We wrote the following code taking into account the instructions to calibrate the load cell provided by the library documentation. I used my kitchen scale and weighed a glass with water (107g).Ģ) Upload the following code to your Arduino board. Your calibration factor will be different than mine, so you shouldn’t skip this section.ġ) Prepare an object with a known weight. You should also have your scale set up (two plates wired on opposite ends on the load cell), and have installed the HX711 library.īefore getting the weight of objects, you need to calibrate your load cell first by getting the calibration factor. Calibrating the Scale (Arduino with Load Cell)Īt this time, we assume you have wired the load cell to the HX711 amplifier and the amplifier to the Arduino board.
0 kommentar(er)
